Frost hit many areas of the Prairies again on the weekend. Some areas in central Alberta reported -8 C. This followed a frosts on a couple nights last week. Two key questions arise after a frost:
Did the crop survive? (Do I need to reseed?)
When can I resume weed control?
How to answer the questions:
Did the crop survive? It can take a few days before you can accurately answer that question. With a light frost of 0 C to -2 C, the risk of crop damage is minimal. With a heavy frost that kills off the cotyledons, it takes a few days before new leaves will start emerging from the growing point between the cotyledons. (Top photo) If no growth occurs within this time, the plant is likely dead. Also, if the stem (hypocotyl) is pinched off or the plant flops over, the plant will likely die. The pinched off or broken stem cannot provide nutrients to the growing point. (Bottom photo)
If many plants have been killed, the question is whether to reseed. Again, it takes a few days to determine the kill rate. If one or two plants per square foot have survived and if that stand is fairly consistent throughout the field, the best choice is probably to leave it alone. A thin stand is not optimal for yield but a thin stand at the end of May has better yield and quality potential than a reseeded field. If large parts of the field are lost, reseeding (or fallow) may be the only alternative for those areas.
When can I resume weed control?
After a light frost, spraying could resume when the following conditions are met:
- A minimum of one night with minimum temperatures of 5 C (the minimum for biological activity to occur),
- A minimum of one day of good growing conditions (warm and sunny) have passed,
- Good growing conditions (warm and sunny) are present at the time of spraying
- You see no evidence of frost damage (blackening and water soaked appearance) on the crop or the weeds. “Crop” is included here because even a herbicide tolerant canola crop requires that the metabolism of the plant be working at full capacity to enable it to effectively process the herbicide and prevent injury.
Always talk to your local product rep to see how they will support the use of their product following a frost or cool temperatures.
After a heavy frost, check for damaged tissues such as water soaked and darkened leaves that eventually lead to necrosis (dead, dry tissue). If tissue damage is greater than 40% of total leaf area, allow new leaves to grow before making herbicide applications.
Weeds stressed and weakened by frost are not more susceptible to herbicide. In fact, herbicide will likely have lower efficacy on weakened weeds.
Because of the above concerns, chemical companies may not be able to guarantee their products’ performance if applied too soon after a frost. And for some products, performance may be reduced if applied at temperatures below (or above) a certain temperature. Check the performance restrictions on a product before using it. Talk to the retailer or check the guide to crop production. Click your province for your guide: Alberta Saskatchewan Manitoba.
No time to wait. Growers who want to do a preseed burnoff and then get seeding may not want to wait 3-4 days for the weeds to recover from a frost. In this situation, growers should recognize that if they go ahead and spray right away, efficacy may be reduced. However, even with the lower efficacy, doing the burnoff and then seeding may provide a higher return than seeding without the preseed burn and letting all the weeds compete until an early in-crop application. Consult with your supplier for information on product performance in these conditions to determine the best approach.
In all cases, it helps to know the weed spectrum and weed sizes before deciding the best course of action. Weigh the pros and cons of each option, and set expectations accordingly.